Live Data/Outputs test not good! Tested on W245, A168, A169 – Reading the control units : 32 Modules (for controller SAK-XC167CI-XXXX)ġ1) Dialink J2534 (blue case, with STM32F105 controller)ĭAS works fine, read all modules and functions. – Reading the control units : 41 Modules (for controller SAK or SAF-XC161CJ-16F40F) Xentry Passthru J2534 Collections and Test Report:Ģ) Openport 2.0 (replace R1 by 47k for better operation and to avoid overheating) Not able to get passthru for Vediamo 5.01.01 at this time as it was not supported. Vas-5054a and Openport would be better choices. you can forget about programming but also the price between them is a big difference. MINI VCI j2534 really works but you have to know that you can only do a scan.
Mini vci j2534 software download software#
Xentry is the same software that is used by dealer. You can even buy Toyota Mini VCI cable for 35$ and also use xentry passthru. Xentry works fine, read 37 modules, fast data transfer on C205.Output test, reset options, basic programming work fine. XENTRY work fine and read 38-39 modules and fast comunication on W212.DAS works fine, read modules, fault codes, erase, adaptation, reset control units on W639 Vito.The newer 211 (facelift) is also no problem. All modules are available including data and DTC reset functions. I’ve installed Xentry Passthru 12.2020 and Tactrix Openport 2.0 CLONE.You’d better replace R1 by 47k for better operation and to avoid overheating. but especially that these devices can be bought for 20-30$ makes them worth it imo at least to get into the whole system. if you want to work with vediamo you can’t use vediamo 5 (4 can’t use smrd files) because vediamo 5 doesn’t support Passthru so your “stuck” with DTS Monaco i wouldnt trust that thing to be able to do ECU SW updates which can take hours cause you’re risking of getting failed uploads and then potentially bricking your ecuģ. you wont be able to access K-Line ECU’s that are widely used in old models (W221, 220, 203, 211, 210)Ģ. The OpenPort 2.0 is confirmed working with xentry passthru, one thing you should consider is thatġ. Same stuff as C4 connect but way cheaper.īuy a tactrix Openport 2.0 original or clone
They’ve used it with Xentry Pass Thru, Forscan, Techstream and Nissan Consult.
Mini vci j2534 software download download#
Also ensure to buy / download Xentry PassThru version.īuy VAS–5054A for 60$ and use Xentry Passthru.Ensure the tool supports SAE-J2534/2 drivers.To have J2534 interface work with Xentry: If you are looking for an J2534 interface that supports Xentry passthru and cost less then a MB SD C4/C5/ C6 clone, these are popular j2534 passthru adapters.
0 kommentar(er)
